About Iaco

Iaco · 11-04-2022

Hi All,I have a problem on the router 1921 the infrastructure is as follows:router isp -> sw -> sw -> router 1921 -> distributorcan someone help me to understand why I can't get to the distributor from the ISP router? this is how the 1921 is configur...

Iaco · 11-08-2022

ping from RTR ISP to Distr.RTR ISP>ping 172.21.1.4Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 172.21.1.4, timeout is 2 seconds:.....Success rate is 0 percent (0/5)RTR ISP>RTR ISP>traceroute 172.21.1.4Type escape sequence to abort....

Iaco · 11-07-2022

it is in hsrp I have two routers with two physical and one virtual ipinterface GigabitEthernet0/0/1.1 --> Primary RTR ISPdescription "Collegamento alla rete LANencapsulation dot1Q 1 nativeip address 10.10.10.3 255.255.255.0standby 10 ip 10.10.10.1st...

Iaco · 11-07-2022

Sh ip int brief from RTR:RTR1921i#sh ip int briefInterface IP-Address OK? Method Status ProtocolEmbedded-Service-Engine0/0 unassigned YES NVRAM administratively down downGigabitEthernet0/0 10.10.10.10 YES NVRAM up upGigabitEthernet0/1 172.21.1.1 YES ...

Iaco · 11-07-2022

this traceroute from ISP to Dist.: (at the moment I can not do the routing from the Distr. to ISP)router ISP>traceroute 172.21.1.4Type escape sequence to abort.Tracing the route to 172.21.1.4VRF info: (vrf in name/id, vrf out name/id)1 10.10.10.3 ...

Iaco · 11-07-2022

this traceroute from ISP to Dist.:router ISP>traceroute 172.21.1.4Type escape sequence to abort.Tracing the route to 172.21.1.4VRF info: (vrf in name/id, vrf out name/id)1 10.10.10.3 0 msec 1 msec 1 msec2 10.10.10.10 1 msec 0 msec 1 msec3 * * *4 *...

Member Since	‎11-04-2022 08:36 AM
Date Last Visited	‎12-30-2022 04:47 AM
Posts	9
Total Helpful Votes Received	5

User Statistics

User Activity

Cisco router 1921 problem

Re: Cisco router 1921 problem

Re: Cisco router 1921 problem

Re: Cisco router 1921 problem

Re: Cisco router 1921 problem

Re: Cisco router 1921 problem