Cisco 9600 core switch is reachable from any IP in our subnet. The main interface is 172.18.112.1 which I use to access the switch web interface. Upon running NMAP scans the switch shows up multiple times on the scans throwing them off. I can access ...
I am apparently unable to get any type of link between a Cisco 9606R C9600-LC-48YL fiber module and a Dell S3148P switch. Dell S3148P Port Config:!interface TenGigabitEthernet 2/49no ip addressportmode hybridswitchportswitchport mode private-vlan tru...
Purchased 3x C9600-PWR-2KWAC for a new Cisco Catalyst 9606 chassis switch. Noticed my C9600-LC-48YL was not getting power, upon inspection my power supplies are only putting out 1K watts each which is under powering the switch. Any suggestions?
Only NAT is behind our firewall but there is not route directly to the core switch from there.On the switch, there is a route for "ip route 172.18.0.0 255.255.0.0 172.18.112.0"
Existing access-list:Extended IP access list IP-Adm-V4-Int-ACL-global10 permit tcp any any eq www20 permit tcp any any eq 443Extended IP access list implicit_deny10 deny ip any anyExtended IP access list implicit_permit10 permit ip any anyExtended IP...
Thank you Reza, if only I knew it was that simple. You have saved me a lot of headaches, after swapping the strands of one of my fiber cables the switches are now showing a link light.Thankyou so much!