Hi, I have setup CME 8.5 on cisco 2851 router, 7911 is working fine , but when i tried to configure 7945 it does not work, it taked ip goes to find term45 but simply shows downloading but within 5 sec goes to blank screen .here is the TFTP loggs-----...
Hi,I am trying to restrict internal extensions to call outside with from 2 truck lines i have done below configuration, but the issue i face is whenever i apply specific Corlist it restricts complete access to trunk. i wanted to do in below way leve...
Hi,I have configured COR, Please advise if i have done it correctly, as it is not working, where am i doing mistake. !dial-peer cor customname Mobilename Localname NWDname Intname UANname Tollname Local-BRname Allname internalname Mobile-GSM!!dial...
Please advise, we have CME 8.1 installed and working , we are upgrading to CME 12, will the load files work already in flash work, or do i need to have them upgrade too.if upgrade of firmware is required , please direct to page.
@Roger KallbergThanks , I tired your recommendation , but unfortunately that did not work.Let me share how i configured it.it was very nice you followed up.
