Hi, Thanks, but that didn't make any difference, I made those amendments and as soon as I removed the line ip nat inside source static 172.16.0.11 220.127.116.11 It failed to apply the dynamic NAT translation.
... View more
Hi All, I've got a new 891 to replace an old 837 and I'm struggling to get the dynamic nat pool working. I've successfully configured the dialer etc for PPPoE and when I set up a static NAT translation between my PC and an external address then I can ping hosts on the internet e.g. ping 18.104.22.168 successfully. But when I remove the static translation and try and use the dynamic NAT pool then no NAT translations take place, and show ip nat translations only shows the other static entries. The relevant bits of the config are below and I've also attached a full (cleaned) config. I've been at this a few days now so any pointers would be much appreciated ip nat pool TestPool 22.214.171.124 126.96.36.199 netmask 255.255.255.248 ip nat inside source list 15 pool TestPool overload ! Can only access internet when static route is defined for my PC ! If I remove this line then it doesn't use the dymnamic pool TestPool ip nat inside source static 172.16.0.11 188.8.131.52 ! ! Add static NAT translations for SIP phones and server. ! ip nat inside source static 172.16.0.2 184.108.40.206 ip nat inside source static 172.16.0.3 220.127.116.11 ip nat inside source static 172.16.0.4 18.104.22.168 ! ip route 0.0.0.0 0.0.0.0 Dialer1 ! access-list 15 permit 172.16.0.0 0.0.0.128
... View more