Hi,in LMS 4.x and DFM you can unmanage a specific interface, port or other component like cpu, psu or sensor of a device.Can't find that functionality in PI 2.0, is it available there?Thanks,Fredrik
Hi,Using LMS 4.1 with an address that are natted I see thatSWIM-jobs to fetch IOS-images are using the server's "un-natted" addressCan't find how to setup the nat-address in LMS so the devices uses that one instead when communicating with the server ...
Hi,On a fresh installed LMS 4.0 (Win2008 Std 64-bit) the discovery exclude filter seems not to work as expectedGlobal seed device configured is 172.30.50.10ip address exclude filter is set to172.16.125.*172.17.125.*172.18.125.*172.20.125.*172.22.125....
Using LMS 3.2 including DFM with snmp-trap notification I'm looking for a way to poll DFM from another system regarding status since trap notification only sends alerts when things do go wrongSo, is it possible to use snmp to poll the DFM / epmdb reg...
Using LMS 3.0.1 with RME 4.1.1 I get an error when trying to distribute images.It's same whether I used "By device" or "by image".The recommendation are run for 90 seconds and then the result are always "failure".I've tried different devices&images.A...
Yes, this is the caseChecked the environment, this is a single router network so the seed device does have an interface address matching the exclude filterI will exclude that address from the exclude filter Regards,Fredrik
ThanksYes, we could take the approach that no alarm means ok.Active notifications will be used to create tickets but clear notifications will also be processedWhatif the link between DFM and external system is down?Is there a queueing mechanism for t...
Hi,seems like they're still down, any news on when they will be available?Have just tried it, but no EoS/EoL hardware or software report , including the PSIRT summary report, can successfully be run(The EoX Software report runs successfully but gives...
After the recommendation phase is finished, there's a status of "failure" in the status field.If I click on the the failure status to get more information, "generic error" is the only thing in the details.I had debug activated and the swim_debug show...