hi,we are using PIX 506 version 6.3 for our network. We have to do static NAT for the VPN connectivity with the client server. But when i try doing PAT i am not able to connect to the remote server. Can anyone help me out why this is happening.Is tha...
I am using L3 3550 / IOS 12.1(22)EA4I have configured 2 VLANs on it, Vlan1 as 10.4.10.65/26 and Vlan2 as 10.232.41.1/24 i have applied access-list as access-list 100 permit icmp any any . I applied it on both the Vlans as ip access-group 100 inip acc...
William,Thanks for ur suggestion,i tried the commands u said but the problem i face is when i do sh vlan it doesn't show the interface can u tell me why it is not visible.waiting for ur reply,Thanks,Vishal.
Paresh,i think i have not quoted the question properly.see by doing 'switchport mode trunk' it will flow the traffic of all vlan right. but if i want to give access of selected vlans then what to do,i have tried the command 'switchport trunk allowed ...
In our network we have 30 Vlans. And it has hundreds of access-list.The access-list is defined with a single ACL number.It is very difficult to trace out the problem because some of them are in use and some are not.So i cannot even remove the old acc...
