Hi, We have LMS 2.6. Today we got one of the blade bad in our 6509 switch but we didn't recieved the alert through LMS.I did checked all the alerts in LMS but couldn;t find it. Error message in the switch logs is *Apr 16 08:37:57.659 DST: %PM_SCP-S...
Hi, I am trying to setup E-mail Notification in LMS. I am not able to see all the devices listed in the notification groups in DFM,same as user defined groups in Common Services in Ciscoworks. How to make sure that all the devices and user defined g...
Hi, I have lately started to recieve large amount of alerts in my Ciscoworks from my few 3550 switches uplinked to a 3750 Core switch. Few of the events are below - 1) EVENT DESCRIPTION = HighUtilization::Component=PORT-10.5.11.207/1.49 [Gi0/...
Hi all, We are using Ciscoworks LMS 2.6 as enterprise wide alerting system.Now,recently our backbone DS3 MPLS link in our data centre went down,which was connecting to service provider PE.Now it resulted in generation on hundreds of alerts and m...
Hi, What is the version running on your WLC,as there is a know bug for MTU less than 1500 on WLC.The solution is to upgrade the controller firmware to 4.0(155)thanksSachin Verma
Hi, For better management and bandwidth allocation you should put all DMZs on sub interface of the single interface.Inside and Outside should be put on seperate physical interfaces. This is the way I had done for similar migration for pix 515E to A...
Hi, Here are some possible causes and resolutions for high memory utilization:Event logging: Event logging can consume large amounts of memory. In order to resolve this issue, install and log all events to an external server, such as a syslog server...