About timbroadaway

timbroadaway · 10-15-2005

This is a very general question, and probably does not have an easy answer. I have recently set up this router to use w/ my cable modem. It has dual ethernet ports and I have the external port set up to dhcp and the internal port set up to static. ...

timbroadaway · 10-15-2005

I have a cisco 2651xm router that I have been configuring. I am just trying to get used to cisco commands and learn, so I will config it, then do an "erase start" and reconfig it. Everytime I do an "erase start" and reload the router it comes up wi...

timbroadaway · 10-14-2005

I have cox high speed internet and want to start using a Cisco 2651xm router instead of my small appliance router. Here is my basic config:cable modem -f0/1 port of 2651xm - f0/0 port into small netgear swtich - pc into netgear switch. (the 2651xm ha...

timbroadaway · 10-15-2005

I am new to configing cisco routers, so I am not sure if there is any problem w/ your config. I wanted to chime in and say that sometimes when ISP's give you a static IP address, you still have to get it via DHCP. They map your pool of static addre...

timbroadaway · 10-15-2005

If I enter that command will it have any effect on thses commands in my config?:service tcp-keepalives-inservice tcp-keepalives-outservice timestamps log datetime msec localtime show-timezoneservice password-encryptionservice sequence-numbers

timbroadaway · 10-14-2005

Thank you very much. I had put the NAT statements in after my initial post and it still didn't work, but after I created an ACL of (access-list 102 permit ip 192.168.1.0 0.0.0.255 any) and applied it to the external interface, that did it for me. T...

Member Since	‎10-14-2005 10:19 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

VPN with a Cisco 2651xm

erasing start on cisco router

Cisco 2651xm/cable modem problem

Re: Cisco 831 Router w/ ISP Static IP Internet Problem

Re: erasing start on cisco router

Re: Cisco 2651xm/cable modem problem