About mjuchim27

mjuchim27 · 07-21-2017

Hi, need some advice; I configured my Cisco 877 Router using some new Public IP address I got from my ISP but when I do a NAT using a pool of addresses; I can't browse the internet. The only way I will be able to browse the internet is if I do a NA...

mjuchim27 · 07-21-2017

Hi Reza, yes if I ping 8.8.8.8 which uses the outgoing interface vlan 5 as per my configuration, it works. Router#ping 8.8.8.8 Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds:!!!!!Success rate is 100 per...

mjuchim27 · 07-21-2017

Hi Reza, thank you for you help really appreciate it. even without the overload, I still cannot browse. Like I mentioned in the original post, this happens only on the fiber link. If I switch over to dsl and use the public ips assigned on dsl netwo...

mjuchim27 · 07-21-2017

Hi, I just modified the config to ip nat pool BTL 190.x.x.147 190.x.x.148 prefix-length 28 and is still not working. See ping from within router. Router#ping 4.2.2.2 source vlan 1 Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 4....

mjuchim27 · 07-21-2017

Hi Reza, thanks for the reply, see below my current router config using fiber link. with the current config I cannot browse. interface FastEthernet0 switchport access vlan 5!interface FastEthernet1!interface FastEthernet2!interface FastEthernet3!int...

Member Since	‎05-04-2015 11:36 AM
Date Last Visited	‎10-16-2017 02:20 PM
Posts	6

User Statistics

User Activity

NAT not working using Pool only when being NAT over an Interface

Hi Reza,

Hi Reza, thank you for you

Hi,

Hi Reza, thanks for the reply