HelloCan someone please suggest what went wrong with this call. I am suspecting something at below lineJan 13 11:25:09.301 MST: //4676818/DC5CF749AF51/CCAPI/cc_api_call_cut_progress:Interface=0x2FFBF40, Progress Indication=INBAND(8), Signal Indicatio...
Hello Gents,I'm seeing following error on one of my CUBE. I know this normally happens due to overlapping dialplan or incorrect translation, but I am unable to find at exact issue in my configuration. I have attached Cube config, Please help! 047161:...
Hello,I want to replace all 1K 9951 with 8865, can I use export phone all detail (for existing 9951.)modify MAC , device type, device security protocol etc, and insert phone all details. please suggest
Hello,
I have Gateway VG01 with 2 PRI from ISP 1 and ISP2. Both these PRI are currently member of Trunk-Group PSTN. This gateway is defined as H323 on CUCM side, so there is no control on ports.
With current setup only 1 PRI trunk from ISP1 is in use...
Hello,
I have configured PLAR on 7841 phone at line 3. Also applied SIP dial rule to phone. PLAR setup is working when EM is not in use. But when users login, pressing button 3 does not do anything.
it looks like PLAR is not working on SIP phones w...
Hello Tony,Answer below 1. Incoming call to unallocated DID would play some sort of announcements from UCM.2. It will not bounce back to UCM, if someone dial outbound call to number withing overall range but outside our DID range, CUBE is setup to ro...
I referenced CUCM hunting just for an example. I believe load balancing can be achieved by using trunk-group hunt scheme round-robin as per below Cisco documentation
https://www.cisco.com/en/US/docs/ios/12_3/vvf_r/vrg_h1_ps1839_TSD_Products_Command...
I have seen this bug ID, but my setup is working on Cisco 8961 SIP phone with EM. I am only facing issue with Cisco 7841 SIP phones. Also My PLAR line is configured on line 3 of UDP and SIP dial rule also configured for PLAR on button 3. I am not fac...