As far As i understand ,you have configure two vlan with one DHCP pool.If my udnerstanding is correct then1.The basic need of vlan was to segment the network,which does not meet if device in two vlans use the same IP segment.2.If you have read you ne...
Considering your request for DHCP i am writing my point of view.
Just configure vlan,SVI ,configure the IP address on that SVI ,remove the IP from loopback or delete loopback.So the device on vlan 100 can request IP from the router(DHCP SERVER).
v...
In Simple words for routing decision1.When packet enters the router it first check the header checksum to detect corruption,If the packet is corrupted ,discard the packet.2.If the checksum pass,router check for the destination IP,If it is router self...
So there are three option you can use to configure static router1. ip route n.n.n.n m.m.m.m next hop address2. ip route n.n.n.n m.m.m.m exit interface3.ip route n.n.n.n m.m.m.m exit interface next hop addressThe issue with route with exit interface...
So How does your routing table looks for those two destination you are trying to reach from the device you are accessing them? It more depend on your routing ,I believe.