About kmacdonald

kmacdonald · 11-07-2017

I have an ASA 5510 appliance we've had for a while now. Previously I had it connected to our switch from the int Eth0/1 to the switch lan port. No Vlans, no layer 3 routing, just unmanaged switching. Now I have 2 vlans configured on my switch (it'...

kmacdonald · 08-26-2010

We have a Cisco ASA 5510 security device. Here recently it seems every day at the same time (between 3 and 4 pm) our internet connection (4 bonded t1's) comes to a crawl. I've looked through the Cisco but haven't been able to find anything useful. ...

kmacdonald · 05-24-2010

I just setup a new Cisco ASA 5510 with the help of the wonderful support staff at Cisco. My setup is as basic as they come: on a t1 going to my firewall then my layer 2 switches to my lan. I need to allow traffic for my exchange server, RRAS serve...

kmacdonald · 05-13-2010

I've been tasked to replace our old sonicwall tz170 firewall with an ASA 5510 and configure it (which I've never done, only routers and switches) and I have a few questions. I'm inside the ASDM and I'm trying to setup my outside interface... The 55...

kmacdonald · 11-07-2017

Thank you for the response. The way the config on the firewall is now, there is no tagging on Eth0/1 (default vlan) interface Ethernet0/1 description Inside LAN interface nameif inside security-level 100 ip address 192.168.200.1 255.255.255.0 ...

kmacdonald · 05-25-2010

This helps greatly! I was just trying to not be redundant with my ACL's. You woudln't see anything you would change?Thank you!

kmacdonald · 05-23-2010

I got it fixed! I had the nat for it going (inside,inside) instead of (inside,outside). I do have another quick question about the SSM card though. Does the port have to be on the network for it to work? I know to manage it I have to connect t...

kmacdonald · 05-23-2010

Ok I got the firewall up and running, internet traffic works great. Problem is I'm having an issue with my NATs Ithink. I setup access rules for my servers inside my network. For example I have an access list that allows any outside traffic coming...

kmacdonald · 05-14-2010

I'll be having fun this weekend! I just configured my pat and my route to my gateway. I'm working on therest now. Thank you so much! If I have issues I'll post my config.

Member Since	‎05-13-2010 10:37 AM
Date Last Visited	‎09-25-2020 12:05 AM
Posts	16

User Statistics

User Activity

Move routing from Cisco ASA 5510 to my Layer 3 Switches

ASA 5500 analyze traffic?

Please critique my ACL

Cisco ASA 5510 config with SSM

Re: Move routing from Cisco ASA 5510 to my Layer 3 Switches

Re: Please critique my ACL

Re: Cisco ASA 5510 config with SSM

Re: Cisco ASA 5510 config with SSM

Re: Cisco ASA 5510 config with SSM