After upgrade to CME 9.0, GUI access accepts credentials and then proceeds to blank page. I verified Flash files, ip http path etc, and all appear correct.
Recently upgrade to CME 9.0 and after ios and phone firmware upgrade I received the error Reg Rej - Max Phones... The CME was operational prior to the upgrade, Show license all showed the license active and the EULA accepted, Telephony-service had ex...
Since we have implemented the UC500 systems at multiple sites I have consitently received complaints regarding the SPA525 model phones in regard to poor audio quality, delayed button response, and constant reboots. I dont receive these complaints on ...
I need to be able to route calls during business hours directly to the receptionist phone and after hours to an AA with a couple of options and GDM. I would like to do this without the receptionist having to activate this service on a daily basis. Ju...
The system I am configuring is replacing an existing phone system. On the existing phone system they utilized an intercom feature button where they pressed intercom and then entered the extension they wanted to intercom with. I am trying to configure...
Answer - View the Read_Me_File where it states:In order to enable GUI on CME 9.0, please add the following IOS commands into the router:Router> Router>enableRouter#configure terminalEnter configuration commands, one per line. End with CNTL...
I am not against upgrading the firmware but my largest concern at this point is the phone reboots. I am used to the 79xx series phones that do not reboot unless the phone is in an idle state which I believe should be the default action on all phones ...
OK, but in my expierance it does work without adversly affecting the CCA or the UC5XX. By not supported I assume that means if an issue arises with the config or with this trunk in particular support will not be available. Seems odd that a SIP trunk ...
