To register a CSR1000v , ISR , ASR as an example  follow these steps for a CSR1000 it is the same for all. --conf t -- license smart enable   --end --- "show run | be call-home" shows the default configuration and per default call-home URL points to ...

When you add more than one NIC to the Satellite be aware that Satellite is acting as a linux end host.  As you may already know a host does not know how to route. When you add 2 network-interfaces you have to make sure you configure it just right or...

Symptoms Satellite version 6.x uses some internal networks for docker communication. ip address range 172.17.0.0/16 and 172.16.0.0/24 .  If you have a conflict and using these networks on the same vlans as Satellite version 6.x is installed, you can...

 If you try and synchronize using Network Synchronization and it fails in STEP 2 of 5 in versions 4.X or 5.X , but manual synchronization works. showing the steps in the picture below.. Check connectivity to api.ciso.com and cloudsso.cisco.com and ...

Symptoms  Can not register your Cisco device to Satellite Smart-licensing-server using HTTPS.  Works when using HTTP.  Diagnosis  Change Call-home URL to use HTTP and see if that works.  If it does you can use the steps below to work around the SS...