I have an ESG and External EPG (SR-MPLS L3out based). I created a 'ICMP' contract with 'icmp' filter in it. I attached this contract as 'consumer' on the ESG and 'provided' on the EEPG. I can then ping EEPG endpoint from ESG endpoint. But I am also a...

Hello, I am working on ACI fabric and have been using EPG with contracts (network-centric), and I want to switch to ESG (application-centric).The bridge domains have specific subnets (192.168.1.0/24 and 192.168.2.0/24) under the same tenant/VRF. Each...

Hi all,I have setup a BD/Subnet/EPG/etc in the ACI environment. I have performed a BGP based L3out to a router as well. From the router, I am able to access only the gateway of the subnet and not other endpoints in the subnet. I have verified the sta...

I am trying to follow the static NAT example from https://www.cisco.com/c/en/us/support/docs/ip/network-address-translation-nat/200255-Configure-VRF-Aware-Software-Infrastruct.html.After setting up, i am trying to ping 172.16.1.2 and it fails. Debugg...

Where can I find a complete ACI L3out topology? I want a hypervisor connected to a leaf switch of ACI and an external router connected with IP addresses, VLANs, routes etc..