About jaimedrq1

jaimedrq1 · 03-11-2012

Hi friends,I have a doubt that I hope anyone can resolve.I am designing a new network following the 3 layers cisco model, and I have the next doubt. (the network is in the image).Imagine that the root bridge of the Switch Block Usuarios is SW5, and t...

jaimedrq1 · 11-02-2011

Hello allCould somebody help me with this subject?I have two routers, one with RIPv1 and the other with RIPv2. In the RIPv2 router I have a static route 172.16.0.0/12 redistributed within RIPv2.When the RIPv1 router receive this route, it learn it co...

jaimedrq1 · 10-25-2011

Hello friends,I am trying to understand some things about how IPsec works and the configuration on a Cisco router.My first question is:Imagin that I have two routers A and B separated by the Internet cloud. I want to create a VPN tunnel between both,...

jaimedrq1 · 07-29-2010

Dear Friends:I would like any could help me whit this subject, because I am turning crazy!In the bytes per packet formula, it says: bytesperpacket=(samplesize(s)*bandwith_codec(bps))/8.For example, with codec G.729 (8000 bps), the result will be: (0....

jaimedrq1 · 03-11-2012

Thank you very much both Jan and Kamil,I think that the static routes is a good idea, I don't know why didn't do this before...I was complicating everything too much... I wanted to mark a route from distribution layer sent from the HSRP router so whe...

jaimedrq1 · 03-11-2012

Hi Kamil, thank you for your answer.The problem that I have is that core layer have redundant paths to access the 172.16.0.0/16 network (Switch Block Usuarios) leardned from RIPv2. But the SW5 is the root bridge for this switch block, and SW6 have mo...

jaimedrq1 · 10-26-2011

Hi Umbernaut,Why you don't try instead of using a pool the next command:ip nat inside source list 1 interface fa 0 overloadIf you have only one direction the pool is not needed.Check the ip address where you are doing the connection, it should be bet...

jaimedrq1 · 10-26-2011

Luiz I need more information to try helping you...Cheers!Jaime

jaimedrq1 · 10-26-2011

Thank you both for your answers.Marcin I appreciate your answer, but I only wanted to know what key is used to cypher the traffic with IPsec, the created in the IKE Phase 1 with the DH Group, the PSK used to authenticate the peer, both, or what? I do...

Member Since	‎07-29-2010 05:22 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	14

User Statistics

User Activity

3 layers cisco design

RIPv1 and CIDR

Two questions

Bytes Per Packet Formula

3 layers cisco design

3 layers cisco design

1811 will not do NAT

RV042 don´t answer PING throw a static route

Two questions