We have a 4 node ONS15454 MSPP UPSR ring running 8.5.4 software. We are running the usual mix of DS1 and DS3 circuits, however I'm trying to standup some ML1000-2 cards to be used to transport some Ethernet circuits across the rin...
We have merged two small offices that are using different VoIP solutions. One office is using a 3825 running CME (8.1) and the other office is running FreePBX (Asterisk 2.9). I believe that I have correctly configured the SIP trunk/Dial Peers so th...
Ryan,It doesn't matter which node I start to build from I get the same indication. I swapped out the ML1000-2 with a ML100-12 and I also get the same indication.Chad
Ryan,When I try and click "next" I get the following error: EID-3246 "The wizard was not able to validate the data. Source is not fully specified". I get this message everytime.Chad
1) Ok, I enabled/disabled VAD....no change.2) On the asterisk side I enabled all codecs and then "sniffed" the call setup from the Asterisk to the CME. On the SIP INVITE message from the Asterisk to the CME, I see all the relevant codecs that the as...
No dial plan patterns on the Cisco side. On the asterisk side I have an outbound pattern that matches the 518X and 519X and sends calls out the SIP trunk to the CME.