I have setup a pptp vpn for windows clients to connect to it works if I give them and ip address on a separate subnet (192.168.12.x) from the subnet they need to access (192.168.1.x) however they need to check use remote gateway on remote network on ...
I have implemented failover using various tutorials on the net including this one http://www.blindhog.net/cisco-dual-internet-connections-without-bgp/ with the difference from the above link being that I use it for failover not load balancing therfor...
I am having trouble getting b-acd to work with unity express. When I dial the pilot number for B-ACD from an internal phone it works fine, however when dialing the CUE AA from internal or over our SIP trunk the call disconects when selecting the opti...
Pinging is not strictly neccassary as I want this for monitoring of primary and backup links from a third party failover dns provider and I can monitor a service port. Basically I want to be able to access services on the 192.168.1.x network from out...
Thats not really what I was looking for, the only traffic I want going over the dsl are wan requests that come to that interface. For example I want to be able to ping the dsl interface from an outside source when the cable is up, or access a webpage...
msobier123 wrote:Hi,I still couldnt understand your setup EXCPET for the NAT config you have posted, Maight be useful if you post Small diagram or the config for your firewall and GRE on the router.However, I understand that you have NAT with floatin...
