About rduke

rduke · 05-04-2009

Have any of you tested the LWAPP 1250 AP with a media converter or combination media converter/PoE injector. - Just wondering if there are any that work OK. I don't need 56 volt PoE since I will only have one radio module installed, but I can't see...

rduke · 01-23-2009

Hello,I am wondering if any of you have tested N adapters with desktop computers and which adapters performed the best.I have tested Broadcom and Intel laptop adapters with favorable results;unfortunately they don't make the same cards for desktop us...

rduke · 09-17-2008

This is the second time I applied an ACS patch to one of our ACS SE 1113 boxes only to have it come up in an unusable state. Today I applied 4.1.4.13.11 from patch level 4.1.4.13.7. I used the GUI to apply the patch. Now most of the services will ...

rduke · 05-05-2008

Has anyone configured their APC UPS network managment cards to authenticate to ACS. The cards support radius, and I have that working, but the user only works as read only. How can I get them to work at at admin level ? I am not sure how to pass t...

rduke · 02-07-2008

I have several ACS 4.0 servers which are authenticating wireless users with PEAP and machine accounts. Everything works fine except that about once every few weeks we have to restart the remote agent on the domain controllers - not at the same time....

rduke · 10-20-2009

Others may disagree, but personally I don't think it is a problem. I used to see this occasionally with wireless devices that are roaming between autonoumous APs. Sometimes a wireless device will roam to an AP on another switch, and you will see th...

rduke · 10-02-2009

I have not tested this in a while so I don't know if Intel fixed it. Where I used to work, I had the same SSID on a and b/g radios. When using the Intel Proset client and the Intel 2915 adapters, the computer would connect to the "a" radio, you cou...

rduke · 09-16-2009

Seth,I bought some 1250 APs to do more or less the same thing. In my case, I want to have N, but only on the 5 GHz radios, and mesh was not going to give me the dedicated bandwidth per AP that I was looking for.Transition networks makes a combinatio...

rduke · 06-01-2009

It is kind of difficult to determine the problem without a lot of digging. One bit of advise. Do not assume the problem is the infrastructure. Test everything - including roaming. I had a similar complaint where I used to work and found the proble...

rduke · 05-20-2009

Dennis,I had to set WMM to "allowed" on the WLAN in WCS to get the higher data rates in addition to using AES. On a side note, I have seen better data rates when disabling laptop wireless card power saving options with some models.Randy

Member Since	‎02-08-2006 07:01 AM
Date Last Visited	‎08-01-2022 09:27 AM
Posts	123
Total Helpful Votes Received	41

User Statistics

User Activity

1250 AP with media converter ?

Wireless N adapters for desktop computers

Anyone else have problems with patches wiping out ACS box

ACS and APC UPS - radius authentication

ACS and remote agent on Windows Domain controller

Re: flapping log on switch (port connect to WirelessAP)

Re: Prefer 802.11a over 802.11g within SSID - Is it possible?

Re: Outdoor's 802.11n

Re: optimizing wireless signal in warehouse

Re: Higher Data Rates than 54 Mbit