About petpkcui1

petpkcui1 · 04-07-2020

Dear all, I've configured authentication Using Ldap server but Failed.After save the configuration and logout to test, I can't access to my FMC with both Local and External User :( Please help me procedure to rollback my FMC configuration from CLI . ...

petpkcui1 · 11-02-2017

Hi everyone, - This is the first time i have setup ASA 5506x FW. I had read some documents that i can connect my PC to interface G1/2 on FW and access https://192.168.1.1 to install ASDM. But after connect to G1/2 on FW, i had no ip address. - I have...

petpkcui1 · 11-01-2017

Hi everyone, I can't type configure terminal command with my asa 5506, does this command has been replaced to the another command? Any one can explain to me this issue ? Many Thanks

petpkcui1 · 09-02-2017

Hi all,I want to receive email from PI when some one changes the running - config on my devices (Switchs or Routers)How can i do it with PI ??? Thanks for any feedback

petpkcui1 · 08-31-2017

Hi all,Can any one can help me on below issueI have Cisco Pi 3.1 , daily i recieve a lot of alarm about link up/down status (hundred larms). I just want to receive status about important links , ex: trunk link. So i changed Interface Alarm policy. B...

petpkcui1 · 11-07-2017

Hi Hamdi, Thanks for help, i've resolve my issue.

petpkcui1 · 11-05-2017

Hi Hamdi,This is output commands:************************************firepower# show runfirepower# show running-config : Saved: : Serial Number: JAD212706WT: Hardware: ASA5506, 4096 MB RAM, CPU Atom C2000 series 1250 MHz, 1 CPU (4 cores):NGFW Versi...

petpkcui1 · 11-02-2017

Thanks for help, MarvinThis is the fisrt time i have used Asa FWNG, it quite different with traditional fw so it very difficult for me .Anyway, thanks for your help :D

petpkcui1 · 11-01-2017

Thanks Marvin,As your comment, i can use enable command if using system support diagnostic-cli.So, must i use asdm to configure parametes like hostname, timezone...Thanks for Help

petpkcui1 · 11-01-2017

Hi all, When i boot it using boot CLI, i have a few options , while FTD , i have more option but i still can't access enable or configuration mode.

Member Since	‎04-05-2017 08:03 AM
Date Last Visited	‎04-08-2020 12:57 AM
Posts	35
Total Helpful Votes Received	5

User Statistics

User Activity

FMC: Restore Configuration from CLI

How to manage ASA 5506x NGFW

ASA 5506X Firepower with Configure teminal command

How to config email notification when the configuration was changed on switch ( PI 3.1)

PI 3.1 with Interface Larm Policy issue

Re: How to manage ASA 5506x NGFW

Re: How to manage ASA 5506x NGFW

Re: ASA 5506X Firepower with Configure teminal command

Re: ASA 5506X Firepower with Configure teminal command

Re: ASA 5506X Firepower with Configure teminal command