About svibert

svibert · 09-03-2004

HiI would like to find the command to check that my QoS configuration of Catalyst 4506 IOS was successful.Typically I would like to see DSCP 46 packet going to tx-queue 3 for example.I have not found the right command on Cisco web site...Thanks

svibert · 08-04-2004

Hi,I am designing a solution based on BT IPClear Flex.What CE router configuration should I go for (Cisco of course). I have so far decided on Cisco2611XM with VWIC-1MFT-E1. Is it correct? Do I need additional cabling?Also would anyone have a configu...

svibert · 03-05-2003

I am designing Network Management Networks and I need to know how much bandwidth I will need to supervise my devices.The devices are routers and switches.The NMS are Cisco WAN Mgt and Cisco LMS.I usually have two routers and 4 switches per site.Does ...

svibert · 10-25-2004

HiI have implemented this solution for a customer.I use eBGP4 redistribution between the SP's PE and my CE.I would cut the /24 into two /25 subnets, subnet1 and subnet2.I would configure the BGP MED with a higher cost for subnet1 and a lower cost for...

Member Since	‎03-05-2003 08:29 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	4

User Statistics

User Activity

Verifying IOS 4506 QoS Configuration

BT IPClear Flex

Bandwidth Required to Manage Routers / Switches

Re: Redundancy AND loadsharing with two HQ sites