I have a tunnel I am trying to setup, and I cannot get the traffic to hit the no NAT, NAT rule. It is bypassing the no NAT and hitting the global NAT rule and the traffic, instead of qualifying for the VPN tunnel is going out the egress interface. I ...

I am trying to clean up the NATing to setup a VPN, but the Nats are overwritting the no nat statements. I am trying to clean them to by adding the source dynamic any interface. The firewall is wanting me to remove them, and I cannot find anything onl...

I have setup a new tunnel between to firewalls, 5510's both of them I used the GUI, set the peers, created the crypto maps in reverse order, set the preshared key, isakmp and ipsec are set. I enabled the tunnel on the outside interface but I am not g...

I have a sub-interface assigned with an IP, name and security zone interface Ethernet0/1.5 vlan 5 nameif FirewallTransit security-level 50 ip address 10.5.1.2 255.255.255.252 when I issue a show int ip br, it is unassigned, I have tried to rebuild ...