Good morning Hi Ruben, thanks for using our forum, my name is Johnnatan and I am part of the Small business Support community. Sorry for the delay of the answer, could you try to configure your router using the port 3389 instead of 3390, here you can see how to configure the port-forwarding http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=346 I hope you find this answer useful, *Please mark the question as Answered or rate it so other users can benefit from it* Greetings, Johnnatan Rodriguez Miranda. Cisco Network Support Engineer.
... View more
Just looked into my RV042 v1... The IP address range is the IP address of your local lan devices. so if your using 192.168.1.0/24 as your DHCP scope then use Tick either WAN1 or WAN2 (not both) Service = https 192.168.1.2 to 192.168.1.254 as the IP range. Direction - Upstream Set your min/max rates Tick "Enable" Click on add to List and Save Setting. Rate Control Interface : Check the WAN interface box, and the Rate Control Rule will apply to the selected interface (s). Service: Select the Service from the drop-down menu. If the Service you need to control is not in the drop down menu list, please click Service Management to add the Service. IP: Enter the IP Address or IP range you need to control. The default is zero which includes all internal IP addresses. Direction: Select Upstream for outbound traffic or Downstream for inbound traffic from the drop-down menu. Mini. Rate (Kbit/sec): Enter the Mini. Rate for guaranteeing bandwidth. Max . Rate (Kbit/sec): Enter the Max Rate for limiting bandwidth. Enable : Check the box to enable this Rate Control Rule. Add to list : After set up the rule, click the Add to list button. The max entry is 100. Simon http://www.linksysinfo.org
... View more