What command do I use to verify connectivity using an SSH session from a router using a destination IP address eg. 10.1.3.11?

Can you help with this lab?Configure Sw1:• Enable DNCP Snooping for VLAN 10• Disable DHCP Option-82 data insertion• Enable DHCP Snooping MAC address verification• Enable trusted interfaces 

I would like to know your thoughts on this lab.IP connectivity and OSPF are preconfigured on all devices where necessary. Do not make any changes to the IP addressing or OSPF. The company policy uses connected interfaces and next hops when configurin...

Can you help with this lab?Configure IPv4 and IPv6 connectivity between two routers. For IPv4, use a /28 network from the 192.168.180.0/24 private range. For IPv6, use the first /64 subnet from the 2001:0db8:acca::/48 subnet.1. Using Ethernet0/1 on r...

Can you help with the following lab. config?Connectivity between three routers has been established, and IP services must be configured in the order presented to complete the implementation. 1. All traffic sent from R3 to the R1 Loopback address must...