I found the following bug but not understanding what it takes to implement the fix. Is this something that TAC as access to or will simple admin access to the CLI be enough? Would appreciate more elaboration on the steps to accomplish this as well.
We are having problems with out 9971 phones dropping off the wireless network. Some of the times it is during a call and some of the time not. The phones will re-register at times but in more extreme cases actually reboot. We have a SSID set up th...
I have been successful in creating a UDP multicast stream that plays on the DMPs, but have not fit the content to the screen. I would like for the content to be full screen if possible. It seems to be scaling it to the safe area. The specifics and...
I want to know if anyone has performed this upgrade. The release notes that I have looked over make it sound like if I want to do the data migration that I must first upgrade the MSE to version 7.0.201.204 and then go to 7.0.220.0. This is only wha...
For some reason I can not access the web interface since doing the 4.1 to 5.0 upgrade. This worked before I did the upgrade on 4.1 and I can ssh into the appliance using its IP address. The setup in the AAI looks right. When I first try to browse ...
I am looking at doing something similar to this for some flexconnect APs that I want to deploy. I would imagine that adding a switchport trunk allowed vlans x,y,z to the initial port config would suffice and that the access vlan would become the nat...
The phones are mostly running 9.4.2SR2-2, some are running 9.4.2SR1-2 and 9.4.2.13
Some are also running bridge mode.
We have not been able to tie the issues to any one difference on the phones.
They are getting power from a brick, no PoE.
We have s...
I would like to know if you got anywhere with this issue. We are facing possibly the same problem as you. We have about 30 of these phones deployed on our wireless network and we have dropped calls and one way audio. We have the devices operating ...
