We have 2 non contiguous /24 from ARIN, our network is broken into 3 major sections, one has its own /24 the other 2 split one as follows204.138.16x.0 /24 204.138.16x.0 /25 --> 204.138.16x.140 204.138.16x.128 /26 Directly connected to router ...
I am trying to set up a new router for training.I am attempting to my First BGP multihome.The router is a 2921.We have a bonded t1 line and a metro ethernet connectionwe have 2 /24 networks 1 /23 and 1 ipv6 /48Behind the cisco router we have 3 Open B...
I am trying to configure my 2921 router to route 2 diffrent ISP's subnets (1 t1 and 1 fiber) they both have diffrent subnets, i have a /28 on both connections1 is ethernet based attached to ge/01the other is serial on seiral 0/0/0:0Both nets terminat...
I checked the traffic flow and the default route is set on the firewall/routers behind the edge device.I can ping the edge router from a from a device behind any of the firewalls. additonaly I can get the the edge routers telnet and ssh from behind a...
Here are the route map configs, My ISP is giving us full internet routes so the out put of sh ip bgp is over 32 mb, just a bit big for a forum postingin its lew I have inclded the output of sh ip bgp neighbors, and the routes advertised.BGP neighbor ...
that fixed the main issue...but now i have another intresting issue,only the first address of isp-b range gets packets the others do not, i would expect that to be a mask issue but my syntax looks ok..