Does anybody know why after I issued the command to use OSPF protocol for routing, I can see a number of routes (using "show ip routes"). But 5-10mins later when I issue the "show ip route" command again. I don't see any routes anymore?
I would like to know if there is any command, technique or recommendations on measuring the bandwidth consumption (in % or bytes/sec) on a Cat 4K switch. Thanks.
Hi, thanks for replying. Yes there are. Its a WAN link (leased line). I can see my other routers at first, but just as I mentioned earlier after a few minutes later, it's gone. Really weird to me.