HelloI have a cisco controller 5520 with more than 300 access points joining it, I found that most of the access points like 250 out of 300 are working on the maximum power level 1 on 5g band only, while on 2.4 bands the power level is within normal ...
Hello,I have a deployment of Cisco 2802I access points, WLC is 5520 running software image 8.5.140.0, and I have a problem where some users suddenly got disconnected and got the yellow exclamation mark on the connection status This issue affects some...
Hello,
my client was having a legacy wireless network in a warehouse environment with ceiling height about 10m high , the legacy AP was 1242 with external antenna where the signal coverage was good and never reported coverage problems, however aft...
Hi All,
I have access points in 2 sites that are joining a regional primary controller and each ap is a member of a certain ap group
we configured a secondary controller to those APs that is located in another physical location "not in HA pair" ...
is it mandatory for the AP fall back option to work to have all the controllers in the same mobility group or not ? Noting that the controllers are not on the same site and they are physically separated in different sites and I am not caring about s...
The wireless design was designed on -67db during the predictive survey, the APs were also placed on the lowest power levels (10W) during the survey "DCA and TPC will be setting the power to power level 1 as it is not seeing the 5GHz neighbors close ...
Till now (this is a new implementation) nothing was reported as slowness or bad performance, but it is a bit confusing for me why the access points are working on the highest power level although the distance between access points are not that far
we are facing a similar issue but with flex connect deployment, the access points use to cache wrong mac address of the gateway router so clients are disconnected disabling the arp caching command is not working as it requires a higher IOSversion on ...
