Hello!I have a problem with sending Calling name through E1 circuit from Siemens Hipath.
I have a follow configuration: Siemens HiPath1 ----E1 qsig---->cisco c2901----mgcp--->CUCM---mgcp--->cisco c2901---e1 qsig--->Siemens HiPath2
When I call from th...
I have an issie with connecting cisco 2901 to Siemens HiPath through BRI. Cisco router is connected to CUCM through MGCP. Outcoming calls work properly, but incoming calls from HiPath fail. Debug q931 shows only this:Aug 3 14:37:52.240 MSK: I...
i would suggest to issue command in config mode:
network-clock-select 1 t1 0/0/0
As I understand, this port is the slave side of connection and you should to set a source of synchronisation for your router.
I assumed the same, but I began to think about Mediasence because of article:
Where I've read:
"One of ...
Currently I choose right solution. Initially I thought to use third-party solution, but I didn't find anything, which could record call from analog gateways.
I'd like to know, can I record calls from analog gateways using Medisense with CUBE d...