Hi Cisco and community..Need help with PSTN disconnect issue on SPA-3102-GW ATA.[I have the latest FW release, 5.2.13 for this unit.]Setup:ATA is configured as PSTN-VoiP gateway. Line1 is registerred to remote PBX, PSTN is register...
Update.....I think I may have found the reason why echo is so prevalent in these units.The IP-PBX I was testing has a 128ms 'echo tail', whereas the 3102 units ONLY has an 8ms 'echo tail'.It would seem the 3102 is not capable of elliminating ALL echo...
I've found echo with the 3102 to be a real issue for a long time and appears it could be an Inherent issue with the SPA-3102.It's all very well to try altering this setting and that settings but end of the day, the echo is still there!My findings sho...
Hi Paul -If I understand you correctlly, I've done this is in the past but with one drawback.What I did was to use an SPA-3102 at the office (which I had connected to a local PBX, which happened to have 4 outgoing PSTN lines - FXO), then at the remot...
Hi David - Disconect tone works fine for 'pure PSTN' calls, incomming / outgoing. The problem exists once the call gets diverted from PSTN to VoiP - through the setting 'VoiP answer delay' setting.If the PSTN caller hangs-up just before the "VoIP Ans...
Hi Dave -Apologies for the long delay...To answer your question, I reside in Australia and I can confirm that this issue Iām experiencing is certainly related to this new F/W 5.1.10..In frustration; I ended up downgrading to 5.1.7; changed nothing, n...
