About fred.appelman

fred.appelman · 03-03-2013

My knowledge is very basic so please bear me with me.I just bought a CISCO892W-AGN-E-K9. This device has two indepent wireless antenna's, an 8 port internal switch plus two WAN links, 1 Gigabit Ethernet and a fast ethernet port and finally a backup I...

fred.appelman · 03-04-2013

Some good news. As I said in the original post I wasn't using the console port. This turns out to make a big difference. If I run the command "sh ip interf brief" from a telnet session I get:cisco-ap#sh ip inter briefInterface IP-Add...

fred.appelman · 03-03-2013

Thank you for the help so far. It will have to wait until tomorrow for futher updates. In the config there is a section:interface BVI1 ip address dhcp client-id GigabitEthernet0 no ip route-cache!Does this mean that this logical interface takes the I...

fred.appelman · 03-03-2013

Yes the SG200 is 10/100/1000. I inserted it for that reason. I cannot remove the bridge group:cisco-ap(config-if)#no bridge-group 1%command not allowed, cannot remove bridge-group 1

fred.appelman · 03-03-2013

I am *assuming* that the Gig interface is the Wan interface. I have connected the WAN inteface will a small switch (Am SG200). On the switch the Gig interface is *NOT* up.

fred.appelman · 03-03-2013

Just to add to my own reply. So I don't know if this the somehow the inside (LAN switch) or the outside (GE). I ping it from both sides just to be sure.

Member Since	‎03-03-2013 01:38 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	10

User Statistics

User Activity

Need some basic help configuring a CISCO892W-AGN-E-K9

Re: Need some basic help configuring a CISCO892W-AGN-E-K9

Re: Need some basic help configuring a CISCO892W-AGN-E-K9

Re: Need some basic help configuring a CISCO892W-AGN-E-K9

Re: Need some basic help configuring a CISCO892W-AGN-E-K9

Re: Need some basic help configuring a CISCO892W-AGN-E-K9