I have a very simple setup. A Netgear router that is connected to WAN and has four ports. If I connect a PC to any port, I get an IP from DHCP (192.168.10.0/24) and the internet is also working. What I want to do is to extend this to a Cisco switch. ...
In short: Is there a better way to find which port switch port a PC is connected to if you have multiple switches?Longer version:I am currently working in a building that has unconventional network design. There are four floors but all the patch pane...
I am creating a VPN with another router and for some reason PFS is not being enabled from my end. Here's my crypto config: crypto isakmp policy 10
encr des
hash md5
authentication pre-share
!
crypto isakmp key ABC123456 address 20.30.40.50
crypto ...
I have two active WAN connetions so I have a route-map for each connection. If I connect a PC to the LAN, everything works fine. But ping doesn't work with a source. If I do ping 8.8.8.8 source vlan 10, it doesn't work. Here's my config:interface Fas...
If I have two WAN connections and I load balance between both, how would it work? Say I open a website and login to my account and these requests gets served by the first WAN. Afterwards the first WAN gets busy and my requests are routed through the ...
I had a default route for the WAN-1 but it was causing issues so I have removed it now. C 10.10.10.0/24 is directly connected, Vlan10
L 10.10.10.1/32 is directly connected, Vlan10
C 10.10.20.0/24 is directly connected, Vlan20
L ...
Ok. I have found the issue. I was checking using traceroute and ping with source on the Cisco router itself and for some reason it never worked. I just connected a computer with the router and everything is working fine! I can use both ISPs.
This is live. I am using Cisco 880. I just changed the public IP address to 1.1.1.1 and 2.2.2.2 in the config I posted. sh ip policy:Interface Route map
Vlan20 PBR
