It looks like both my HSRP Interfaces (VLAN 600 & 700) cycle through standby --> active ---> speak continuously on one of the two switches. What can be causing this?*May 4 06:41:24.883: %HSRP-5-STATECHANGE: Vlan700 Grp 0 state Speak -> Standby*May ...
Equipment:HP Blade Enclosure C7000HP GbE2c Ethernet Blade Switches (x2) [We will call these switches 1 & 2]Cisco 6509 (x2) Core Switches [We will call these switches A & B]Current Setup:The servers in the HP Enclosure have dual NICs that connect to e...
I have a question about the picture attached. The diagram shows each Cisco 4948 connecting to each Cisco 6506. Since there are only two 10GB ports, there are no ports available to connect the Cisco 4948 (trunk) to each other. I currently have one ...
Scenario: I would like to setup multiple DMZs for our hosting servers. Currently there is a single DMZ in which our reverse proxy servers are connected using a public IP address. The idea is to have the reverse proxy forward the request from th...
I am trying to determine whether to configure L2 or L3 between the core switch and the access closets. The core switches are 6509-E and the access closets have 3750x-48P-L switches (stacked). There are 5 switches on the second floor and 3 on the fi...
Jon, Currently I have one DMZ where the reverse proxy lives. The appliance is connected to gig 7/47 and is a memeber of VLAN 200. VLAN 200 is assigned to the FWSM and has a public IP. I want to create two more DMZs (DMZ2 and DMZ3). What you are...
Allen, I have updated the drawing to show the change between the FW and the IPS routers. If we are unable to do HSRP at the FW level, then I will have to contact the ISP and have them change the /29 to a /30 and assign the IP's accordingly. We own...
After reading up some more on the FWSM and 6509, I have decided it would be best to design the network so the MSFC is on the inside. This would allow me to NAT on the FWSM and then connected the FWSM directly to the ISP routers. This way I do not h...
Brenden, The Barracuda proxies have not been connected to the network because I am unclear where or how to attach them. This network is also being built and currently has no users so I can configure whatever is needed. In the past when I used an A...
Mike, With the 6500, you have to install the Sup engine in specific slots depending on the chassis size:Slot 1 or 2 in 3-slot chassisSlot 5 or 6 in 6-slot or 9-slot chassisSlot 7 or 8 in 13-slot chassisYou have the option of two slots if you have re...
