Hi Guys,I am new to cisco Asa firewall ,, so spare me if i will ask basic doubts .. if I want to configure ASA in Active / standby mode , then their interfaces should be in same subnet Ip.Now , say for e.g for DMZ & inside zone I a...
hi guys,i am facing very strange issue with multicasting.All the router's interfaces are configured in "ip pim spare mode: . Now i have enable auto-rp feature (not BSR),Without configuring "ip pim auto rp listener " , i am able to ping from source to...
Hi All.,,i hve one requirment if you can help me outI have multilple sites connected via site-to-site ipsec vpn tunnel to HQ terminting on the same interface on HQ. Requirmet is to redirect traffic coming from all the sites to one...
Dear All,I am planning to design a netwrok with full redundancy in lan as well as wan.Attached is my network topology.Below are my requirements :- 1) Configuring cisco asa in Active/standy failover.2)Running a routing protocol (probobaly EIGRP) b/w L...
I suppose you guys are correct....But my doubt came because in Juniper SRX firewall you can assign diffrent Ip address......chekout this link :-http://www.juniper.net/techpubs/software/junos-security/junos-security10.0/junos-security-swconfig-securi...
Hi jamil,Can u elborate more what information u need from this out...I can tell below information from your outputThe prefix 8.8.8.0/24 belongs to AS-15169 which is google ..7018 is AT&T AS no. , next hop is 12.123.134.124 which is AT & T ip.What e...
Great Nandan,You really resolved this mystery.....So its clear now that my toplogy and test results shared by John , listner command is not required since ther are few routers....., So the assumption we can draw here is that , it realy depneds on th...
Hi nandan,good points and testsYou may be correct with the assumptions u r drawing with ur test results ..But have u tried keeping MA & RP on different router and then check .... because in my solution they are diffrent...