Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We want to dual home our voice gateway router to two 6500s in VSS configuration. Is it best to create two small subnets to routed interfaces on the cores and let EIGRP take care of the redundancy and load balancing? I would register the gatew...
Hello, We have some new secure IP phones that we are trying to get to go secure with some STE phones that are PSTN connected. We can call the STE phones no problem but when we try to go secure it fails. The manufacturer is telling me they will only ...
Hello, I have a couple of EX90s here that I want to get dialed in. I can connect and do video conferencing with all of our vid conf devices. The thing I'm trying to do is get incoming calls from the PSTN to ring this thing. I can get it to ring by se...
I've just had the please of moving some of our offices in Asia onto our Australia Call Manager. In Australia they use 0 for secondary dial tone, in Asia they use 9. My delima is this, we have an ARC console server there that when set up they used DNs...
I've just put a + in front of all our numbers in AD and have found that our Attendant Console will not dial these numbers. We get a busy tone like the call can not be competed as dialed. What do I need to do on CM to get the + sign recognized or ig...
Hello Alok,Please see answers below: So this is my understanding of your setup.Calls come from PSTN gateway router and hits to CUCM to a DN. This DN as you mentioned is configured for SNR and then CUCM routes this to remote destination configured und...
Hello Vivek, Thank you for your help. The log command is not working. I get the following:log ctx SipPacket debug 9Command not recognized.From: vivsing2 To: anthonymd Date: 03/26/2012 03:31 PMSubject: - Re: EX90 and CUCM HomeRe: EX90 ...
