JamesHawkins
Level 1
Level 1
Member since ‎10-03-2023
‎02-10-2025

User Statistics

  • 40 Posts
  • 1 Solutions
  • 22 Helpful votes Given
  • 7 Helpful votes Received
Recent Badges
First Discussion
5 Discussion Posts
5 Helpful Vote
30 Discussion Posts
20 Discussion Posts
First Comment
10 Discussion Posts
1 Reply
20 Replies
1 Accepted Solution

User Activity

Hello, I have a customer with CUCM 14SU1. They have recently purchased a VG410 which has 48 FXS ports which connect analog phones at one of their sites. The VG410 is not supported as an SCCP gateway until CUCM 14SU3 so I have set it up with dial peer...
Hello, I have a customer with a CYCM 14 cluster who has recently added a new site that has quite a few analogue phones. A Cisco VG410 48 FXS port gateway was installed to connect these analogue phones. The VG410 is quite a new device and is not suppo...
Hi, I have a customer on CUCM 14 with 8841 and 8851 IP phones. The default ringtone for these seems to be "Sunrise" which seems to be the same whether the caller is an inside caller or an outside caller. For 7900 phones the default ringtone changed a...
Hi, I have configured a VG410 48 port gateway for use with CUCM. The CUCM cluster does not support the VG410 as an SCCP gateway so I have configured it as a SIP device and pointed a CUCM SIP trunk to it. Calls seem to work ok but after a seemingly ra...
Hi, I have a CUCM 12.5 system where a Call Pickup Group is not working as it should. I have checked the CSS and Partition setup and all phones are assigned CSS's which have access to the Partition containing the pickup number. However when I use Dial...
Community Statistics
Member Since ‎10-03-2023 04:25 AM
Date Last Visited ‎02-10-2025 03:46 AM
Posts 40
Total Helpful Votes Received 7