Hi,
based on the output:
E3#show ip bgp 181.0.0.0/8
BGP routing table entry for 181.0.0.0/8, version 5
Paths: (1 available, best #1, table default)
Not advertised to any peer
Refresh Epoch 1
1 2
10.100.1.1 from 2.3.4.5 (11.11.11....
Hi,
the record option does not work. First Ping without "record" Option:
R3#ping
Protocol [ip]:
Target IP address: 192.168.100.1
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]: y
Ingress ping [n]:
Source ...
The ip address I am trying to ping is reachable, see the first output. The difference between the first and second command is just the Record Option. Without the Record Option, everything works fine...
Hi, I had the same problem some days ago. I found out, that it seems to be only possible to increase the metric, not to decrease the metric.You can increase the Bandwidth, the Delay, the Load and the Reliability, but you cannot change the RD directl...
Found Solution for IPv6... but Solution for IPv4 is still missing.
router ospfv3 1
!
address-family ipv6 unicast
area 10 virtual-link 5.5.5.5
exit-address-family
!
Any Idea for IPv4?
That is true, I want to do Inter-VRF-Routing on Router R1.
All 4 Pings are Pings from Router R2 (vrf red) to vrf blue on both Routers.
With IPv4 everything works fine, the IPv6 Ping from
R2 (red) --> R1 (red) --> R1 (blue) --> R2 (blue)
wo...
