Having trouble finding the steps to add the ATA 191 firmware to Callmanager 11.5. Currently, our Callmanager only has the 186, 187, & 190 options.Could someone point me in the direction to add the sha512 and zip files?Thanks,Scott
Looking for help to bond 2 NICs on a Barracuda Backup appliance. The 2nd NIC on the appliance has been activated by Barracuda support. If NIC 2 (connected to gi1/0/8) is active, I can not ping the device. If I shutdown port gi1/0/8, I can ping the...
Trying to update the firmware on a 7925G but have been unsuccessful. Using a Win7 64-bit machine with a USB connection.Phone's current firmware = CP7925G-MFG-F.2.LOADS Method 1: Accessing the phone's browser. Used the Phone Upgrade option to uploa...
Pulled out an old 7925G wireless phone. Phone was connected to an earlier version of Callmanager a few years ago. We are now running Callmananger 11.5. Firmware on the 7925G was 1.0(?) I think. Newer firmware was downloaded, but now the phone doe...
Running Prime Infrastructure 3.5. Under Unified AP (Inventory/Device Type), I have one 3702 AP listed as a Cisco 1040 Series AP. After looking in several places, the Antena Name is Internal-1040-5.0GHz for this AP. The model is listed as AIR-CAP37...
Factory reset does not make a difference. Checked after the reset, CTL file was cleared. I've also tried a firmware update using recovery mode without any luck. Boot the phone in recovery mode. Access phone with browser. System Load ID shows CP7...
Not even getting the update via TFTP. Our Callmanager v11.5 has the firmware version CP7925G-1.4.8.4. From the 1.4.8 release notes:Upgrade from Releases Prior to 1.4(3)If your Cisco Unified Wireless IP Phones are currently running a release prior to ...
Same results. Used the hotspot on my phone to try the upgrade. Phone shows downloading firmware, but after the transfer, computer shows "Phone Upgrade (Error) Error in uploaded image".
I have tried a different laptop, earlier firmware (v 1.3.1), and a different 7925G without success. Browser (IE 11) shows Phone Upload Status bar transferring file. Then shows "Error in uploaded image". Any other suggestions?
