Hi Giorgio, Thanks for your response. I already have my outgoing & incoming dial peers and relevant voice translations configured and currently all IP phones registered on the UC520's CME are working perfectly. They make and receive PSTN calls smoothly with DID through an E1 line. I was only meant to setup the 4 FXS/DID ports to provide the same functionality for Analog phones. The phones can make on-net calls back and forth with IP Phones, they also receive incoming PSTN calls. However PSTN nos dialed from the Analog phones match the right outgoing dial-peer (seen from debug voice ccapi inout) but then returns a fast busy tone without the call going through. I have checked everything and can't seem to find the problem, please help! Below is my partial config. voice-port 0/0/0 station-id number 1234 caller-id enable   dial-peer voice 1234 pots destination-pattern 1234 port 0/0/0     ... View more

Hello, Pls I need help in configuring an analog phone connected to VWIC3-4FXS/DID to be able to make pstn calls. currently it is making local calls to IP phones but when PSTN no is dialled, it responds with a fast busy tone. it's unclear why it does this. Appreciate your help. ... View more

Thanks a lot. Very helpful Cheers!! ... View more

Thanks a lot for this info, but what I need clarification for is how they make the payment. We know that every Cisco product is ordered using an SKU, but in this case what part number will apply and who will order it or pay on their behalf? Thanks. ... View more

Hmmm... Like they will pay online or what? I mean if the current SMARTNET can access the file and download it, how then does the payment come in? Thanks. ... View more

Thanks Experts. Please I also want to ask about the feature set license upgrade on the same switch Currently, their SMARTNET covers the switch with 12.2 feature set ADV IP W/MPLS/IPV6/SSH/3DES + BGP, but they want to upgrade to 15.1 Adv. Ent Services. Can they use the same SMARTNET contract to download it? If no, what will they order to have the access to download it? Thanks and best regards. ... View more

Hi Reza, It's Sup720 ... View more

With Eval Data License, you should be able to run IP SLA. But you can also turn on Eval Sec License and see what happens. I tried your snmp command above (snmp-server view rttmon ciscoRttMonMIB included) on a router with Sec & UC and it worked ok. ... View more

Hi Gupta, You need to upgrade from IPBase License to a minimum of data license or something higher (Security or UC license) to be able to run IP SLA command on any ISR G2 Router. Check the following URL for more clarification: http://www.cisco.com/en/US/prod/collateral/routers/ps10616/white_paper_c11_556985.html#wp9000807 You can also optionally activate any of the Technology Licenses by following the steps below; Router>enable Router#configure terminal Router(config)#license boot module c1900 technology-package securityk9 Router(config)#exit Router#reload please note that you may be prompted to accept End User Agreement in the activation process, that's fine. That will give you 60 days of evaluation and you can run any of the commands supported while you purchase the license you need. The URL above will guide you on the license to upgrade to. HTH ... View more

Hi Gilberto, Please clarify something, I have a customer having the IP Base license on 2911 and has the same issue. so they can buy the security license only, and IP SLA will work without the data license ? ... View more