About nbaker011

nbaker011 · 05-06-2020

Hi, could someone please confirm what license i need to enable the firewall on the C931-4P? I believe its this: SL-19-SEC-K9=, is that correct?

nbaker011 · 04-21-2020

Hi - I have a couple of VLANs defined on my router (a CISCO 800 series ISR) and a hierarchy of SG300 switches to handle the traffic between clients. For the most part all is working fine, except that the SG300 switches seem to quite happily pass all ...

nbaker011 · 02-08-2017

Hello, I'm trying to convert over from using ACL/CBAC rules to Zone Based. I've looked a several examples and to just get the basics going seems simple enough, but I can't quite get things to work. I suspect there is some hangover from the CBAC confi...

nbaker011 · 12-10-2016

Hello, I can't seem to figure out how the access rules on the RV325 are supposed to work (assuming they are supposed to work). Say I have an application I want to let through the firewall from a specific address on WAN1, I create a rule that allows t...

nbaker011 · 12-08-2016

I suspect I'm running into a non supported configuration. The situation is that I have a range of public IP addresses provided by my ISP, e.g.: 10.10.10.254 << modem / gateway address 10.10.10.249-254 << public static IP for me to use 255.255.255.248...

nbaker011 · 04-22-2020

Hi Ajay - thanks for the reply. I think my question is somewhat different - I've expanded with a simple diagram. For the sake of an example, I have two subnets configured on the router and currently just using separate ports rather than ROAS. VLAN1 i...

nbaker011 · 02-09-2017

Thanks, yes, removing those lines worked. Maybe unrelated, but it then locked me out of ssh when I did this, so I need to find the serial cable again before trying the rest. Thanks, Nick.

nbaker011 · 12-11-2016

Tried the same scenario out on a 800 series router and it worked as expected. Something odd with the RV325. Solution seems to be to upgrade to something that works.

nbaker011 · 12-10-2016

Bump

nbaker011 · 12-08-2016

Thanks - yes the theory was that I could have two VLANs on the LAN side one connected to say the 10.10.10.249 public network and the second for the 10.10.10.250 public network address. I'm doing this with two routers today, but after upgrading to the...

Member Since	‎09-21-2015 02:02 PM
Date Last Visited	‎05-08-2020 12:06 AM
Posts	23

User Statistics

User Activity

Correct license to enable firewall on C931

SG300 intervlan routing and switching

ISR C891F Trouble setting up zone based firewall

RV325 creating access rules

891F Dual WAN configuration with same subnet (overlap error)

Re: SG300 intervlan routing and switching

Thanks, yes, removing those

Tried the same scenario out

Bump

Thanks - yes the theory was