My current setup is as followsPBX to VOIP routers - WAN - VOIP router to PBXCalls are getting connected and the phone rings at either site, when someone picks the phone up there is just silence.any suggestions?Thanks in advance for any help
I have set up VOIP between to sites.Each site connects from a PBX to router then accross the WAN.Site A calls site B, phone rings, user answers but there is no sound at either end!!! complete silence.Can anyone helpThanks in advance
Can some confirm the type of RJ45 cable needed to connect E1 port on router to E1 port on PABXalso has anything change on cisco E1 port over the last few years i.e pinouts?
I had a problem with my voip config,after some good advice from this forum I have made some change to the config.are there any commands i can use to make a test voip call between the routers, so i can check if the new config works.
current set upsite 1Router connected to PBX by E1Site 2 router connected to PBX by E1End to end to IP connectivity has been check and is workingProblemwhen trying to make a VOIP call the user gets a dial tone from the router, after dialing the teleph...
There is full routing between the 2 routers accross the WAN, there are also no firewalls in place or ACL's on any router interfaces.is there anything else i should be looking at, or any other possible causes to this problem?
framing has been checked and all is well.the connection between the pbx and the routers looks ok.user picks up phone and gets dial tone from router but when they dial second site they get engaded tone.please see attachment from my "gw-accounting"
