Hi, I have a cisco 3550-12T.Its a layer 3 switch. I have customers connected from this l3 switch. This switch doesnot cupport rate limit command but I need to restrict internet bandwidth for those customer as soon as possible.Done Bgp with those cust...

HI,I have cisco 2950 and cisco 2900.Had a trunk between both the switches.The problem is i got lots of input errors in the connected switch in only one port.Both are set to speed 100 and duplex full.The errors often seen wwhile configuring speed auto...

Dear All,I have 2 links from 2 different ISP.I have got cisco router in my end.Got 2 interface and in both i have the 2 link connected.My problem is: whenever one link goes down mainly marked as primary , other marked as secondary should work automat...

Dear All,Customer has 2 link connected between 2 different distribution point thru optical fiber. same ip address is configured at both the end routers. Current situation is that one link is in shut mode till his running link goes down. he want the ...

Hi All,Using dual and single strand for fiber connectivity, what will be the best among these two.single or dual??