My T1 VWIC card on my UC520 had the alarm led on and the T1 controller and serial interface are both down.How to determine if the problem is local or remote?I have attached my current configuration on the UC520
Need to intercept incoming calls from PBX through the T1 connection and providerouting rules based on the incoming number. Right now incoming calls receive dial tone from UC520which is the best way to accompligh this?
we just purchased an VWIC2-1MFT-T1/E1 card trying to look for any guies that would describehow to install it and configure it.We will be setting up a T1 ISDN PRI connection with our Avaya PBX.we have an Idea of the configuration on the Avaya PBX side...
can I download the default factory configuration files for the UC520 from the cisco site?I have been trying to use the factory file in flash, but it is not restoring the default factory configuration.Please advise.
Hi Marcos, I try these settings and it didn't work. The calls from the PBX just receive dial tone.under the dial peer do I have to assign a port in this case like 0/2/0:23?Is it possible to change the dial plan on the uc520 to match the PBX extations...
Thanks Marcos, in my case I'm routing DIDs from my PBX to the UC520 this are 4 digit stations. I need to do digit translation herefor example and incoming station 3939 needs to ring on IP phone ext 702
Hi Steve, I'm having a really hard time getting the UC520 to talk to the Avaya PBX. I'm confirming the settings on the Avaya side, but on the UC520 side I havesome doubts. I used the CCA as you suggested and set the switch type as primary NI.Show run...