Member since ‎10-14-2009

User Statistics

  • 101 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 4 Helpful votes Received
Recent Badges
1 Helpful Vote
1 Accepted Solution
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Setup are 2 UCS blades in 2 datacenters 50 miles apart. However the backbone between the 2 is 40 Gigabits. The UCS's are connected with fiber at 10 gigs to a Cisco 3750 switch which is also 10 gigs. The San in one Datacenter is an EMC Isilon and the ...
I had an ESXi host on a UCS blade and in that the VLAN 138 was configured right from the ESXi host. I rebuilt the blade as a physical Server 2008 host and the nic in the physical server under properties under Configure does not have the standard VLAN...
This was an ESXi host that I want to setup as a physical Server 2008 R2 server. Where I get hung up is the Installer give me grief that the partition is GPT and can't do the Windows one. So I attached the Driver DVD for the Cisco UCS B200 M2 and it d...
In mucking around with my 4500 I accidently deleted the ip address that I use to get into it with telnet and CNA. I have a console cable hooked up to and I'm in that way but the commands I got off the internet did not work. Those commands were set in...
I was checking some things on my Cisco 4500 and spot checking some of the ports. Using CNA it says it is at 10.The web browser to the switch says Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000-TX on port 6i/18The CNA says, so wha...
Community Statistics
Member Since ‎10-14-2009 05:42 PM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 101
Total Helpful Votes Received 4
Helpful Votes From