About kimek4901

kimek4901 · 07-03-2018

Hello, I have a problem with Catalyst 4900M and inlet temperature for module. Temperature went up few days ago and now it`s below alarm threshold but it`s still showing warning cause it didn`t went down more then 5C. Anyone know how to change thresho...

kimek4901 · 01-23-2017

Hello, I have a problem with admin account for my ACS. Someone locked it out and now I cannot login and do changes. I`ve tried to boot ACS with recovery CD and reset password but it doesn`t reset login attempts. Some ideas how to reset this counter o...

kimek4901 · 12-14-2016

Hello, I have a switch 2960X with a power problem. It looks like two interfaces Gi 1/0/41 and Gi 1/0/42 (upper, lower) goes into power faulty state when Cisco 7911/ 7942 is connected. Log show TStart error on those ports even after 2xmode is applied...

kimek4901 · 05-19-2015

Hi,I`m new in telepresence solution and I need help. My company is planning to create a big conference room with such requirements:- 3 screens (Center: big videowall, 2 smaller screens left,right)- 2 cameras (50-100m cable needed)- 1 or 2 microphones...

kimek4901 · 04-07-2015

Hello,Some time ago I took administration of Call Manager from someone else and I have few phones from which only serial was scanned and listed in Altiris and I dont know where they are or even if they`re configured or not. When I`ll have MAC I`ll be...

kimek4901 · 12-16-2016

Thank you guys for your time and sharing knowledge Regards, Marcin

kimek4901 · 12-15-2016

Hi Paul, Yes, other ports are working fine, only two goes into faulty state of poe. I thought that it`s a hardware issue on those two switches and I`ll have to replace them but I wanted to try my luck and submit a question :)

kimek4901 · 02-16-2016

Hi, I always get involve my purchase department and they contact cisco partners. You can find partners here: https://tools.cisco.com/WWChannels/LOCATR/openBasicSearch.do Yes , you need to buy licenses separately. Check how are your phones licensed (e...

kimek4901 · 02-15-2016

Hi, From what I know you need to buy physical Call Manager Server where you`ll have installation DVD. I don`t know any other legal method. Additionally you also need to buy licenses for every phone/extension you want to use with Call Manager. * I don...

kimek4901 · 02-10-2016

Hi Jeffrey, Do you have authentication setup on switch? It can be related to 802.1x config on ports. Regards, Marcin

Member Since	‎02-23-2015 02:01 AM
Date Last Visited	‎07-18-2018 12:03 AM
Posts	24

User Statistics

User Activity

Catalyst 4900M temperature

ACS - CLI admin locked out

2960X - power inline faulty on interface

Telepresence solution in big conference room

How to get phone MAC from Cisco

Thank you guys for your time

Hi Paul,

Hi,

Hi,

Hi Jeffrey,