Hi Folks,
I am wondering if any one could let us know what is the difference between universal-id and rotate when you configure ip load-sharing and try to avoid traffic polarize? I have gone through the cisco document but the only thing I got was t...
Hi Folks
Could someone please let me know would those switch ports that having portfast enabled still undergoing blocking and forwarding status change (downtime involved) in the case of STP root switch changing event or they will stay out of the dis...
Hi Folks,
I am wondering when I implement BGP fall over command, Do I need to implement this command on both end of the routers to make the BGP session to be disconnected as soon as the link is down or as long as one end is implemented with that com...
Hi Folks,really confused on following BGP path selectionsBGP routing table entry for 1.0.16.0/23, version 18808717Paths: (3 available, best #3, table default) Not advertised to any peer Refresh Epoch 1 1174 21914 22519, (received & used) 140.60...
We are going to convert to BGP, However there are few things I am not sure which road I should go down at the moment, it would be grateful if anyone here could give me some suggestions.SenarioWAN:We have two ASR routers connecting to Transit provider...
Thanks for your reply Mark. So for instance, if switch port 1-10 that configured in Vlan 300 with portfast enabled and the switch is running in PVST mode. When the STP vlan 300 root bridge changing from current root bridge to another root bridge, are...
It's depending on how you could like to setup your network.I probably would suggest to put all your internal network behind a/pair of firewalls with different zones to ensure the layer 2 and layer 3 seperation and security. And using your core switch...
Thank you for your reply Vivek,That probably explained why, as I did shut down the BGP sessions with140.60.10.77 previously to let BGP peer to carry out some urgent jobs and re-enabled the BGP session with140.60.10.77 after job completed. If any othe...