About steve.potter

steve.potter · 05-07-2009

I'm trying to set up two routers connected to each other using RS232 (smartSerial) cables (one DTE, one DCE). Have set the serial ports into 'async mode dedicated', and encapsulation ppp but I cannot get the link to come up. The status (on both sid...

steve.potter · 05-14-2009

I could do that, but the problem is I will ebventually need to interface to an 'external' async bearer, and it will almost certainly only be a 3-wire connection. The b2b config is just to test it in our lab.Steve.

steve.potter · 05-10-2009

I think I may have confused things! I'm not using the CEM cards for the 'back-to-back', I only refenced it to show that the cables had been tested out. The back-to-back is definately using the WIC-2T (using ports Serial0/3/0 on each router)Hope that...

steve.potter · 05-07-2009

Show command outputs attachedFor info, I have used the cables on a CEM card, they are identified correctly (DTE/DCE RS232), and work OK there.Appreciate your time Edison, thanks.

steve.potter · 05-07-2009

Yes I did try that, and although the command was accepted, it didn't seem to do anything (ie didn't appear on a 'show run')

Member Since	‎05-07-2009 05:52 AM
Date Last Visited	‎09-18-2019 01:01 AM
Posts	5

User Statistics

User Activity

Back-to-back routers using a WIC-2T in async mode

Re: Back-to-back routers using a WIC-2T in async mode

Re: Back-to-back routers using a WIC-2T in async mode

Re: Back-to-back routers using a WIC-2T in async mode

Re: Back-to-back routers using a WIC-2T in async mode