About jimgrumbles

jimgrumbles · 03-03-2020

We're running CUCM 10.5(2) and I'm trying to get a 7914 expansion module up and running with either a 7960G or 7961G. In both instances the module just sits there with the first lamp blinking red. Not ALL the lamps as many troubleshooting documents...

jimgrumbles · 08-09-2012

Hi,I've been polishing up on my CCSP since I'm currently in a job where I don't have to touch a lot of that stuff. While doing a lab I setup an IPSec site to site VPN between two IOS routers. For example: https://www.cisco.com/en/US/products/ps9422/...

jimgrumbles · 10-10-2008

Twice in the past two weeks my ASA 5520s in an Active/Standby setup have failed over when it appears there should have been no reason to.I think this is is 3 or 4 times total they've done it since I implemented them. After the first false failover m...

jimgrumbles · 04-11-2008

I'm trying to disable NAT from our Linux subet (192.168.8.0) to our DMZ (192.168.5.0) but am failing miserably.On the IT subnet (192.168.1.0) identity NAT works perfectly, the PC of my workstation translates to itself on the DMZ. So I though, easy e...

jimgrumbles · 04-10-2008

I'm trying to SSH from 192.168.1.240 to 192.168.5.23 but not having any luck. The Linux server has two NICs, one is 192.168.5.23 and the other is 192.168.7.16. The default gateway for this server is set to 192.168.7.1. If I set the default gateway...

jimgrumbles · 06-08-2016

Hello, Can anyone from Cisco confirm whether this process for checking disk alignment in 8.6 is still the most current/accepted? I opened ticket 639127619 asking how to check the disk alignment in 8.6 and the response was: "If you do the configurati...

jimgrumbles · 02-12-2016

How viable is this tool for an ASA 5550 8.2 to 8.4 migration? My only option when running this is to migrate to an ASA-5555X running 9.1(4). How useful would that config be in migrating from 8.2 to 8.4? Would it do more harm than good? From my re...

jimgrumbles · 01-15-2016

Check your RADIUS reject delay settings on your RADIUS server. I had to set mine from 1 to 0. https://supportforums.cisco.com/discussion/11893201/web-auth-mac-filter-failure-radius#comment-11075696

jimgrumbles · 01-15-2016

This was a bad NIC on the printer.

jimgrumbles · 12-04-2015

Did you ever find a solution for this? We're having an issue with a Ricoh Aficio 2851 with a static IP that won't populate the MAC table on a 2960X but if we move it back to a 3560 or 3750 it comes right back up and is pingable immediately. I confi...

Member Since	‎04-12-2007 09:25 AM
Date Last Visited	‎03-09-2020 09:00 AM
Posts	41
Total Helpful Votes Received	5

User Statistics

User Activity

7914 Expansion Module single blinking red light / Does not show up in phone/web GUI

IPSec VPNs and routing

ASA 5520s failing over when they shouldn't

Failing at Identity NAT

Can't SSH to Linux server IP in DMZ

Hello,

How viable is this tool for

Check your RADIUS reject

This was a bad NIC on the

Did you ever find a solution