Please advise me.my client insisting to set a dscp value of 56 (= CS7 , the highest priority) for their video packet without any bandwith restriction in the input of fast ethernet port and PPP Multilink serial output port of the 7513 router. Please ...
hione 4507R switch having vtp domain with many vlans (vlan 20 vlan 30 , vlan 40 vlan 50 .....etc..) with ip interfaces and all other swithes 3500, 2600 series are connected by trunk link and vtp client with vlan access port and all system and server ...
hello!one of the vlan (vlan 20 ) is in one 4507 switch with ip address and all vlans are routed but one link is via no switchport with ip address to different switch and devices (3560 and ASA5520) and to different network but there one of the client ...
please tell me what is " L2 Fwd Low " in cisco 4507 switch ? showing " cat4k mgmt loPri, cpu utilization, Host Learning, L2 Fwd Low " are high in cisco 4507 switch. What can be the reason behind that ?
acl to deny any ip communication between two different vlans (different ip network) in cisco 4507 switch doesn't work but when the same acl is applied by vlan maps then it works perfectly. please clarify ?
Dear Peter,Thanks for your reply, I totally agreed with you, with CS7 the network will be totally at the mercy of video bandwidth consumption, routing and ncp, ipcp everything will be effected.Is anyone ever done any such configuration with CS7 ? I a...
thanks for the reply,no SVI is defined in vlan 1, and i already tried by defining a different ip network SVI in vlan 1 of the VTP domain switch 4507 to eliminate this point and this is why with vlan 30 only ?i don't think that somewhere someone has...
Thanks for your help, 13 vlans are configured other then native and default vlans as vtp client in 2960 , all vlans are allowed in trunk link and ip default network ip in 2960 from vlan interface ip in 4507 but the observation is same even if i rem...
Thank you for the attention but i can not disclose the actual IP address as per restriction and policy the fact required to resolve my problem follows as:networks are IP X.X.X.X, A.A.A.A , B.B.B.B , C.C.C.C , .........with VLAN 20 , VLAN 30 , VLAN 4...
many many thanks for your reply. we are connecting client from inside zone (high security) to out side zone server(low security)by 3rd party (different vendor)ipsec in transport mode by routed mode ASA 5520. how can the client be connected to server...