I'm looking at the release notes here http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a00808330a9.shtml#config where it says"Note: When you have a WiSM installed on a switch that runs Cisco IOS Software Re...
>>the internal port-channels towards the two processors of the WISM will be LACP, no other way as far as I know.Thats not what I was asking. I know that the WISM requires etherchannel with no way to turn it off like on a 4404. I am not trying...
Yes. WEP and WPA is allowed on the same SSID as long as you are at 4.0.206 or later. You can do this by creating two WLANs on the same controller. The controllers will allow each WLAN to have the same SSID *only* as long as they effect a different...
The command (requires enable level) you want to determine if the AP has Manufacture Installed Certificates is: "test pb display"Example below AP *HAS* MIC ap1# test pb display------------------------------Display of the Parameter Block--------------...
To keep failed attemps from beating up on your servers use the commanddot11 holdoff-time From the documentation:dot11 holdoff-timeUse the dot11 holdoff-time global configuration command to specify the hold-off time for EAP and MAC address authenticat...
